Product Information for:
Advance Products & Systems Monolithic Isolating Joints
IsoJoint is a true monolithic isolating joint. The most up-to-date, patented joint on the market, IsoJoint does not depend on the use of isolating sleeves and washers for bolts, nor isolating gaskets or O-rings between flanges. Why? These isolating gasket kits require a critical, even surface and proper placement of a sealing element to provide regular and variable crushing, and must be maintained over the life of the isolator. External pressure causing an uneven load on the flange area can result in loss of isolating properties as well as the transported fluid.
IsoJoint employs one or more, preassembled pressure seals and the isolating rings. Unlike isolating gasket kits, IsoJoint does not depend on installer’s actual fitting of the joint’s isolating gasket, sleeves, and washers, and the possible loss or damage to any one of the number of these materials, which would result in complete breakdown of the isolated flange. One lost or damaged part will render these flanges useless. The monobloc design of the IsoJoint allows the joint to be welded into place as one piece, virtually eliminating any field problems. Unless a meticulous on-site assembly and overwrapping is undertaken in the installation of the isolating gasket kits, gradual penetration of moisture will erode the electrical resistance. This problem, along with the others listed above, makes inspection and maintenance necessary. Contrary to this inconvenience, IsoJoint’s technique and design of the pressure seals coupled with the closure weld guarantees that the specified mechanical and electrical properties will always be maintained allowing for direct burial and requiring no maintenance.
♦Specific hydraulic internal pressures are maintained.
♦Isolating requirements are met and surpassed in regard to the electrical characteristics of the product carried in the pipeline.
♦IsoJoints are designed according to ASME VIII, Division I.
♦All testing is done in-house. Hydrostatic and electrical are standard. Ultrasonic, X-ray and dye penetrant testing can be done if requested. Testing voltage 3000 v-50 Hz. Electrical resistance -5 Mohm minimum. Test pressure: 1.5 times working pressure. Working temperature up to 160°F. Customers may require special test values.
♦All coatings are applied in-house. Standard joints are coated internally and externally with epoxy-resin coatings. Different standards as per customer’s requirements. NSF approved internal coating is available.
♦Earthquake resistant – Acts as a thrust block or joint.
♦Existing and new construction.
♦Gas, Oil, Liquid Petrochemical, and Water Lines.
♦Before and from gas distribution lines.
♦On gas or liquid fuel tanks.
♦Under or over ground usage.
♦Riser connections on platform.
To Order Please Specify:
♦Diameter of pipe
♦Grade of pipe material
♦Product to be transported
♦Temperature of transported material (160ºF is standard. Higher temperature materials available upon request.)
♦Additional X-ray, Non-destructive testing. Electrical and hydrostatic testing is standard. (Please state requirements)